Ensemble RX II Inventorys
Component Inventory
This page provides a list of components and their maximum quantities to support your inventorying the kit as a whole. This is helpful for kits where the kit includes all parts necessary to build any particular band-specific option (there would, in such cases, likely be excess parts left over at the end of the build).
Once these quantities check out, you can sort the components out to their respective build stages.
Note: mag wire furnished with the kit is approximately 35 feet. Shunt wire for jumpers required may be obtained from cutoff leads.
Component Type | Category | Component | Qty |
---|---|---|---|
boardhdw | HDW | 4 X #4-40 hdw (nut, bolt, washer, spacer) | 1 |
Capacitor | Ceramic | 0.01 uF (103) | 1 |
Capacitor | Ceramic | 0.015 uF 5% (153) | 2 |
Capacitor | Ceramic | 0.047 uF 5% (473) | 4 |
Capacitor | Ceramic | 100 pF 5% (101) | 2 |
Capacitor | Ceramic | 1000 pF 5% (102) | 2 |
Capacitor | Ceramic | 1500 pF 10% (152) | 2 |
Capacitor | Ceramic | 180 pF 5% (181) | 2 |
Capacitor | Ceramic | 1800 pF 5% (182) | 2 |
Capacitor | Ceramic | 3300 pF 5% (332) | 3 |
Capacitor | Ceramic | 390 pF 5% (391) | 5 |
Capacitor | Ceramic | 4.7 uF 10% 16V X7R RAD (475) | 5 |
Capacitor | Ceramic | 680 pF 5% (681) | 3 |
Capacitor | Ceramic | 6800 pF 5% (682) | 3 |
Capacitor | SMT 1206 | 0.1 uF ((smt) black stripe) | 20 |
connector | Jack | BNC Connector Male - PCB mount | 1 |
connector | Jack-RA | 3.5mm stereo jack - PCB mount (rt-angle) | 1 |
connector | Jack-RA | DC Power Jack PCB Mount (rt-angle) | 1 |
connector | Jack-RA | USB-B pcb jack (rt-angle) | 1 |
connector | Plug | DC Power Plug 5.5/2.1mm Pos Ctr | 1 |
Diode | Axial | 1N4003 (1N4003) | 1 |
Diode | Axial | BZX55C3V3 3.3V zener diode (BZX55C) | 2 |
IC | DIP 8 | ATtiny 85-20 PU w/V15.12 Firmware (AVR ATTINY85-20PU) | 1 |
IC | DIP-4 | LTV-817 Opto-Isolator (LTV 817) | 2 |
IC | I2C | Si570 Programmable Oscillator (SiLabs 570) | 1 |
IC | SOIC-14 | 74AC74 Dual D FF (74AC74) | 2 |
IC | SOIC-16 | FST3253 mux/demux switch (FST3253) | 3 |
IC | SOIC-8 | LT6231 dual op-amp (LT6231) | 1 |
IC | SOT-23-5 | LP2992AIM5-3.3V regulator (LFEA) | 1 |
IC | TO-92 | LM78L05 voltage regulator (LM78L05) | 1 |
inductor | Binocular core | BN-43-2402 (no markings!) (none) | 3 |
inductor | Toroid | T25-6 toroid core (yellow) | 6 |
inductor | Toroid | T30-2 toroid core (red) | 9 |
inductor | Toroid | T37-2 toroid core (red) | 3 |
PCB | Main Board | Ensemble RX PCB (board) | 1 |
Resistor | 1/4W | 10 ohm 1/4W 1% (br-blk-blk-gld-br) | 4 |
Resistor | 1/4W | 4.99 k 1/4W 1% (y-w-w-br-br) | 2 |
Resistor | 1/4W | 49.9 ohm 1% (yel-wht-wht-gld-brn) | 2 |
Resistor | 1/6W | 1 M 1/6W 5% (brn-blk-grn-gld) | 1 |
Resistor | 1/6W | 10 k 1/6W 5% (brn-blk-ora-gld) | 5 |
Resistor | 1/6W | 120 1/6W 5% (brn-red-brn-gld) | 4 |
Resistor | 1/6W | 2.2k 1/6W 5% (red-red-red-gld) | 12 |
Resistor | 1/6W | 68 1/6W 5% (bl-gry-blk-gld) | 3 |
Resistor | 1/6W | 75 1/6W 5% (vio-grn-blk-gld) | 4 |
socket | Socket | 8 pin dip socket | 1 |
wire | Cutoff | shunt wire (cut-off lead) | 7 |
wire | Magnetic | Magnetic Wire, enameled #30 | 2 |